On Wed, Jul 8, 2009 at 3:48 AM, Adam Kirchhoff (via DragonFly issue
tracker)<bugs@crater.dragonflybsd.org> wrote:
>
> Adam Kirchhoff <adamk@voicenet.com> added the comment:
>
> I recently installed 2.2.1 on a Dell Precision 490. It has one bge0 nic. =
=A0It
> works fine with the GENERIC UP kernel. =A0When I rebooted into an SMP ker=
nel that
> I built, though, I started getting the watchdog timeout errors. =A0I foun=
d this
> report and set hw.bge0.tx_coal_ticks to 400 in sysctl.conf, but that didn=
't
> change anything.
>
> Anything else I can test? =A0The NIC in question:
>
> bge0@pci11:0:0: class=3D0x020000 card=3D0x01c11028 chip=3D0x160014e4 rev=
=3D0x02 hdr=3D0x00
> =A0 =A0vendor =A0 =3D 'Broadcom Corporation'
> =A0 =A0device =A0 =3D 'BCM5752 NetXtreme BCM5752 Gigabit Ethernet PCI Exp=
ress'
> =A0 =A0class =A0 =A0=3D network
> =A0 =A0subclass =3D ethernet
Did you have APIC_IO in your kernel configure?
If "yes", then try removing APIC_IO and try again.
Best Regards,
sephe
--=20
Live Free or Die