Max Laier wrote:
> Am Sa, 16.02.2008, 09:11, schrieb Tofig Suleymanov:
>
>> Hello hackers,
>>
>> I will be grateful if someone could point me to the right direction
>> regarding the question below.
>>
>> My device driver is getting incoming packets fine, but for some reason I
>> am not able to send a single packet. Here is the source code:
>>
>> http://www.freebsd.az/if_ib.c
>>
>> I've added several debug messages to the source and here is the output:
>>
>> (bringing interface up and assigning the ip/netmask combination)
>>
>> ifconfig ib0 192.168.0.6 netmask 255.255.255.0 up
>>
>> (At this moment I get this in my /var/log/messages. It seems to be a
>> gratuitous arp who-has packet )
>>
>> Feb 7 19:14:32 schizo kernel: ib_init entered
>> Feb 7 19:14:32 schizo kernel: ib_start entered
>> Feb 7 19:14:32 schizo kernel: ib_encap entered
>> Feb 7 19:14:32 schizo kernel: DHOST ff ff ff ff ff ff
>> Feb 7 19:14:32 schizo kernel: SHOST 0 c0 ee 22 3 14
>> Feb 7 19:14:32 schizo kernel: txeof entered
>> Feb 7 19:14:32 schizo kernel: txeof exiting
>>
>> (now I try pinging, but no joy . I've added extra debug messages inside
>> ping.c)
>>
>> schizo# ping 192.168.0.1
>> PING 192.168.0.1 (192.168.0.1): 56 data bytes
>> packets sent: -1
>> ping: sendto: Invalid argument
>> packets sent: -1
>> ping: sendto: Invalid argument
>> packets sent: -1
>> ping: sendto: Invalid argument
>> ^C
>> --- 192.168.0.1 ping statistics ---
>> 3 packets transmitted, 0 packets received, 100% packet loss
>>
>>
>> I have also tried to add debug messages to sys/net/if.c and
>> sys/net/netisr.c and it seems that the kernel doesn't even try to run my
>> ib_start() function.
>>
>> Doing tcpdump on the interface and pinging does not show any packets
>> flowing. Please note that tcpdump shows the arp who-has request right
>> after I assign the ip address.
>>
>> ifconfig ib0 gives the following:
>> ib0: flags=1008c3<UP,BROADCAST,RUNNING,NOARP,SIMPLEX,NEEDSGIANT> mtu 1500
>>
>
> Why do you set NOARP? It seems that your ping can't figure out the ARP
> address of 192.168.0.1 and hence returns early. Either install a static
> arp entry for 192.168.0.1 or lose the NOARP.
>
Good catch !
I've added a static arp entry as advised and now I am getting into
ib_start() and ib_encap() successfully !
Kind regards,
Tofig.
_______________________________________________
freebsd-hackers@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-hackers
To unsubscribe, send any mail to "freebsd-hackers-unsubscribe@freebsd.org"