I just got another lockup.
It looks like in the time of lockup the number of Ierrs is increasing:
Name Mtu Network Address Ipkts Ierrs Idrop =
Opkts Oerrs Coll
em2 1500 <Link#3> 00:14:4f:XX:XX:XX 13060395 18438 0 =
6579984 1 0
After "ifconfig em2 down;ifconfig em2 up" Ierrs stays at 0 rate for long =
time.
Without DEVICE_POLLING it was similar situation.
Regards, Rolandas Naujikas
On 2010.11.20, at 18:24, rolnas@gmail.com wrote:
> On 2010.11.20, at 17:54, Jeremy Chadwick wrote:
>=20
>> On Sat, Nov 20, 2010 at 05:09:28PM +0200, rolnas@gmail.com wrote:
>>> I'm experiencing network interface stalls on em in FreeBSD =
8.1-RELEASE (-p1).
>>> It looks like the problem could be solved in 8-STABLE, but should I =
upgrade to it ?
>>> Is it OK to try to get only em driver code and recompile as module =
and try to run it ?
>>>=20
>>> sysctl dev.em.2.stats=3D1:
>>> ...
>>> em2: Missed Packets =3D 101334
>>> em2: Receive No Buffers =3D 488
>>> ...
>>> em2: RX overruns =3D 1356
>>> em2: watchdog timeouts =3D 1
>>> ...
>>>=20
>>> Only "ifconfig em2 down;ifconfig em2 up" helps for some time.
>>> The same happens on em0 interface only, but not in the same time.
>>> It is production (NAT) router with pf+pfsync+carp and failover over =
another router.
>>> They are old "SunFire X4100" boxes (4GB RAM, 2*2 AMD Opteron =
2.2GHz).
>>=20
>> You're going to need to provide output from the following, run as =
root.
>> For the pciconf command, please only include the entry that's =
relevant
>> to the device in question (em2). You can also XXX-out the MAC =
address
>> and/or IP addresses if you're worried about security.
>>=20
>> $ pciconf -lvc
>=20
> em2@pci0:1:2:0: class=3D0x020000 card=3D0x10118086 chip=3D0x10108086 =
rev=3D0x03 hdr=3D0x00
> vendor =3D 'Intel Corporation'
> device =3D 'Dual Port Gigabit Ethernet Controller (Copper) =
(82546EB)'
> class =3D network
> subclass =3D ethernet
> cap 01[dc] =3D powerspec 2 supports D0 D3 current D0
> cap 07[e4] =3D PCI-X 64-bit supports 133MHz, 2048 burst read, 1 =
split transaction
> cap 05[f0] =3D MSI supports 1 message, 64 bit=20
>=20
>> $ dmesg | grep em2
>=20
> em2: <Intel(R) PRO/1000 Legacy Network Connection 1.0.1> port =
0x9400-0x943f mem 0xfbfa0000-0xfbfbffff irq 24 at device 2.0 on pci1
> em2: [FILTER]
> em2: Ethernet address: 00:14:4f:XX:XX:XX
>=20
>> $ sysctl dev.em.2
>=20
> dev.em.2.%desc: Intel(R) PRO/1000 Legacy Network Connection 1.0.1
> dev.em.2.%driver: em
> dev.em.2.%location: slot=3D2 function=3D0
> dev.em.2.%pnpinfo: vendor=3D0x8086 device=3D0x1010 subvendor=3D0x8086 =
subdevice=3D0x1011 class=3D0x020000
> dev.em.2.%parent: pci1
> dev.em.2.debug: -1
> dev.em.2.stats: -1
> dev.em.2.rx_int_delay: 0
> dev.em.2.tx_int_delay: 66
> dev.em.2.rx_abs_int_delay: 66
> dev.em.2.tx_abs_int_delay: 66
> dev.em.2.rx_processing_limit: 100
>=20
>> $ uname -a
>=20
> FreeBSD sunfire1.mif 8.1-RELEASE-p1 FreeBSD 8.1-RELEASE-p1 #2: Thu Nov =
18 10:39:07 EET 2010 =
root@sunfire1.mif:/home/local/obj/usr/src/sys/SUNFIRE amd64
>=20
> Recompiled with DEVICE_POLLING and HZ=3D2000, carp and many not used =
devices removed.
>=20
>> $ netstat -ind -I em2
>=20
> Name Mtu Network Address Ipkts Ierrs Idrop =
Opkts Oerrs Coll Drop
> em2 1500 <Link#3> 00:14:4f:XX:XX:XX 66430440 101334 0 =
59339619 1 0 0=20
> em2 1500 192.168.0.0/1 192.168.XX.XXX 633845 - - =
3815946 - - -=20
> ...
> em0 1500 <Link#1> 00:14:4f:XX:XX:XX 167143400 152726 0 =
143900328 0 0 0=20
>=20
> Regards, Rolandas Naujikas
>=20
>> Thanks.
>>=20
>> --=20
>> | Jeremy Chadwick jdc@parodius.com =
|
>> | Parodius Networking http://www.parodius.com/ =
|
>> | UNIX Systems Administrator Mountain View, CA, USA =
|
>> | Making life hard for others since 1977. PGP: 4BD6C0CB =
|
>>=20
>=20
_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "freebsd-stable-unsubscribe@freebsd.org"