課程名稱︰分析化學一
課程性質︰必修
課程教師︰劉春櫻
開課學院：理學院
開課系所︰化學系
考試日期（年月日）︰2008/10/20
考試時限（分鐘）：120分鐘
是否需發放獎勵金：是
（如未明確表示，則不予發放）
試題 :
Analytical Chemistry (Total: 113%)
1. Explain the difference between (21%, a-e: 3% for each, f: 6%)
(a) a colloidal and a crystalline precipitate
(b) specific and selective precipitating reagent
(c) sample standard deviation and population standard deviation
(d) random and systematic error
(e) coefficient of variation and standard deviation
(f) Volhard method and Fajans method in the chloride determination
2. Explain the term "spike recovery". The recovery is often less than 100%,
why? (6%)
3. State why standard additions and internal standards, instead of a
calibration curve, are desirable, and why? How to choose and appropriate
internal standard? (10%)
4. How is a control chard used? State six indeications that a process is going
out of control. (6%)
5. The solubility product Ksp for the silver salt AgX is 4.0(±0.4)*10^-8.
What is the molar solubility of AgX in water? (6%)
6. Neglecting any effects caused by volume changes, would you expect the ionic
strength to (1)increase, (2)decrease, or (3)remain essentially unchanged by
the addition of NaOH to a dilution of
(a) magnesium chloride [Mg(OH)2(s) forms]?
(b) hydrochloric acid?
(c) acetic acid?
Please give the reason for your choice. (9%)
7. Find the molar solubility S of silver chloride in 0.04M sodium nitrate. The
o
activity constant for Ksp = 1.765*10^-10 (10%)
8. A chemist obtained the following data for percent lindane in the triplicate
analysis of an insecticide preparation: 7.47, 6.98, 7.27. Calculate the 90%
confidence limit for the mean of the three data, assuming that
(a) the only information about the precision of the method is the precision
for the three data.
(b) on the basis of long experience with the method, it is believed that
s→σ =0.28% lindane. (10%)
9. From previous measurements of a low concentration of analyte, the signal
detection limit was estimated to be in the low nanoampere range. Signals
from seven replicate samples with a concentration about three times the
detection limit were 5.0, 5.0, 5.2, 4.2, 4.6, 6.0, and 4.9nA. Reagent
blanks gave values of 1.4, 2.2, 1.7, 0.9, 0.4, 1.5, and 0.7 nA. The slope
of the calibration curve for higher concentrations is m = 0.229nA/μM.
(a) Find the signal detection limit and the minimum detectable
concentration.
(b) What is the concentration of analyte in a sample that gave a signal
of 7.0nA? (10%)
10. How to determine the protein content in the milk with Kjedaho method? (15%)
11. The dissociation constant Kd for AgCl in aqueous solution has a value of
5.0*10^-4, its solubility product is 1.82*10^-10. Calculate the solubility
of silver chloride in water and the percent of the dissolved solute that
is present as the undissociate comound. (10%)
(附有表 "Values of Student's t")
--
※ 發信站: 批踢踢實業坊(ptt.cc)
◆ From: 114.44.8.113