1.calibration check: 週期性地檢查calibration以確保儀器的calibration curve
沒有偏差 每次都得使用不同的standard solution
quality control sample :每隔一段的樣品作鑒測已發現品質μ+_ 3*σ/√n
或是其他不正常狀況
2.intra-assay precision :同一個人同一天同一儀器進行replicate measurement
以看 reproductivity
intermediate precision :不同人不同天同一儀器比較DATA之reproductivity
3.detection limit :偵測極限確保訊號跟雜訊有明顯不同常訂為3S
sensitivity :指濃度作變化時訊號變化大小在calibration curve 即為其斜率
m=(signal change/concentration change)
4.confidence level:信心水平表示這個實驗的精準度對應student's t上的X%
confidence interval:+-t*s/√n表示有X%機率true value 是落在該區間用來估計
error bar
5.variance: σ^2標準差平方
standard deviation (那個公式) 表是高斯分布之寬度 精度越大 σ越小
6.linear range:calibration curve中signal正比於濃度的區域
dynamic range:校正曲線中所有濃度和signal有關且足夠specification之 range
包含linear range
7.F test :F=s1^2/s2^2(s1>s2)可查表看此兩標準差的差異大小
Q test :Q=gap/range 查表看data point 保留或刪去
8.z:把高斯分布的X用標準差換掉z=(x-μ)/σ
t:student's t用作建立confidence interval
9.accuracy 準確度指距離true value有多近
precision:精準度指measurement之reproductivity
10.systematic error:系統誤差可能來自實驗設計的缺點或儀器問題具再現性且可被
detect並移除
random error:隨機誤差來自其他uncontrolled 因素例如electrical noise 產生
Gaussian distribution
11.auxiliary complexing agent :在EDTA滴定時避免metal ion在鹼性下
形成hydroxide沉澱而加入Kf比OH-大 但比EDTA小
masking agent:EDTA滴定時先加入以去除另外的matal ion的干擾像Mg2+ Al3+
add F-
12.indirect titration:利用某salt(BaSO4)的stoichiometry關係間接定出anion之量
SO4 2-
back titration:當不能用indicator時會先加過量EDTA再用Mg2+定出EDTA過量多少
回推 matal ion之量
13.method blank:包含所有樣品處理過程但沒加入分析物之blank
reagent blank:和method blank類似 但不包含所有的procedure
14.standard solution :已知有true value 的標準液用作校正之用1
blank solution:用來測定matrix對signal 影響
15.false positive :正誤差測得的比true value大
false negative :負誤差測得的比true value小
今天到這小多真是強
--
※ 發信站: 批踢踢實業坊(ptt.cc)
◆ From: 140.112.7.59
※ 編輯: jasonfghx 來自: 140.112.7.59 (01/20 22:09)